4.6.3.4. Weighting to Improve Fit

4. Process Modeling
4.6. Case Studies in Process Modeling
4.6.3. Ultrasonic Reference Block Study

4.6.3.4. Weighting to Improve Fit

Weighting

Another approach when the assumption of constant variance (homogeneous) of the residuals is violated is to perform a weighted fit. In a weighted fit, we give less weight to the less precise measurements and more weight to more precise measurements when estimating the unknown parameters in the model.

Finding An Appropriate Weight Function

Techniques for determining an appropriate weight function were discussed in detail in Section 4.4.5.2.

In this case, we have replication in the data, so we can fit the power model

to the variances from each set of replicates in the data and use

for the weights.

Fit for Estimating Weights

Dataplot generated the following output for the fit of ln(variances) against ln(means) for the replicate groups. The output has been edited slightly for display.


LEAST SQUARES MULTILINEAR FIT
SAMPLE SIZE N       =       22
NUMBER OF VARIABLES =        1


PARAMETER ESTIMATES           (APPROX. ST. DEV.)    T VALUE
1  A0                   2.46872       (0.2186    )          11.
2  A1       XTEMP      -1.02871       (0.1983    )         -5.2

RESIDUAL    STANDARD DEVIATION =         0.6945897937
RESIDUAL    DEGREES OF FREEDOM =          20

The fit output and plot from the replicate variances against the replicate means shows that the a linear fit provides a reasonable fit with an estimated slope of -1.03.

Based on this fit, we used an estimate of -1.0 for the exponent in the weighting function.

Residual Plot for Weight Function

The residual plot from the fit to determine an appropriate weighting function reveals no obvious problems.

Numerical Output from Weighted Fit

Dataplot generated the following output for the weighted fit (edited slightly for display).


LEAST SQUARES NON-LINEAR FIT
SAMPLE SIZE N =      214
MODEL--ULTRASON =EXP(-B1*METAL)/(B2+B3*METAL)
REPLICATION CASE
REPLICATION STANDARD DEVIATION =     0.3281762600D+01
REPLICATION DEGREES OF FREEDOM =         192
NUMBER OF DISTINCT SUBSETS     =          22

FINAL PARAMETER ESTIMATES           (APPROX. ST. DEV.)    T VALUE
1  B1                  0.147046       (0.1512E-01)          9.7
2  B2                  0.528104E-02   (0.4063E-03)          13.
3  B3                  0.123853E-01   (0.7458E-03)          17.

RESIDUAL    STANDARD DEVIATION =         4.1106567383
RESIDUAL    DEGREES OF FREEDOM =         211
REPLICATION STANDARD DEVIATION =         3.2817625999
REPLICATION DEGREES OF FREEDOM =         192
LACK OF FIT F RATIO =       7.3183 = THE 100.0000% POINT OF THE
F DISTRIBUTION WITH     19 AND    192 DEGREES OF FREEDOM

Plot of Predicted Values

To assess the quality of the weighted fit, we first generate a plot of the predicted line with the original data.

The plot of the predicted values with the data indicates a good fit. The model for the weighted fit is

6-Plot of Fit

We need to verify that the weighted fit does not violate the egression assumptions. The 6-plot indicates that the regression assumptions are satisfied.

Plot of Residuals

In order to check the assumption of homogeneous variances for the residuals in more detail, we generate a full size version of the residuals versus the predictor variable. This plot shows that the residuals now exhibit homogeneous variances.